PC-34 is a pump controller with a digital display that allows the user to set the start and end pressure values via the panel according to actual needs, and intelligently detects the water pressure and flow rate in the pipeline to start and stop the pump.
This digital pressure controller starts and stops the pump according to the pipeline water pressure and flow condition. It completely replaces the traditional pump control system consisting of a pressure switch, separate water shortage protection, and a non-return valve.
Features:
- Dry-running protection
- Automatic pump control
- Real-time pressure display. User can set the starting and ending pressure as required
- Built-in check valve
- Periodic duty cycle option
- Possibility to set the switch-on and switch-off pressure
- There are three operating modes: Auto, Manual, Time
Installation:
When installing, pay attention to the direction of water flow through the device. There are arrows embossed on the connectors showing the correct flow direction.
If the device is to operate in an installation where the pressure is over 10 bar, a pressure reducer must be installed upstream of the device to reduce the pressure in the device.
It is best to seal the connections of the PC-34 controller with pipes with Teflon tape.
The maximum height of the water column above the regulator depends on the switch-on pressure setting and cannot be higher than the height of the water column corresponding to the switch-on pressure.
The switch-on pressure should also be selected depending on the pump's capabilities.
If the PC-34 controller is to function properly, the pump must be able to generate a pressure that is at least 1 bar higher than the switch-on pressure (the minimum difference between the switch-on and switch-off pressure is 1 bar).
FAQ – Frequently asked questions about the PC-34 controller
What is the PC-34 controller used for?
Driver PC-34 is used to automatically control the pump operation based on the pressure in the water system and the flow. It allows you to set the start and end pressure, replacing traditional pressure switches and dry-running protection. Thanks to the digital display and intelligent detection of operating parameters, the device automatically turns the pump on and off, ensuring convenience and safety.
Who is the PC-34 controller intended for?
PC-34 is a solution for pump users who expect greater control over the operation of the water installation. It is suitable for single-family houses, gardens, farms and smaller industrial plants. It is especially recommended where automation with dry-running protection and the possibility of precise pressure regulation are required.
What functions does the PC-34 controller have?
Driver PC-34 has a number of functions, including: protection against dry running, digital pressure display, ability to set the on and off pressure, built-in non-return valve and three operating modes - Auto, Manual, Time. The device can also operate cyclically, which increases its versatility in various installations.
How to properly install the PC-34 driver?
During installation, pay attention to the direction of water flow - it is indicated by arrows on the body. If the system pressure exceeds 10 bar, a pressure reducer must be installed upstream of the device. It is best to seal pipe connections with Teflon tape. The height of the water column above the regulator cannot exceed the value corresponding to the switch-on pressure. The pump should be able to generate a pressure of at least 1 bar higher than the set switch-on pressure.
Where to buy IBO devices and pumps?
