Pumps are devices commonly used in industry and households. Their integral element is the engine that drives the working tool that produces the necessary pressure difference between the suction and discharge side. It is thanks to this that it is possible to pump the liquid or transport them to a higher level. There are many types of pumps on the market, among which one of the most commonly used are submersible pumps for sewage, sludge and drainage. Sewage pumping devices are usually equipped with a cutting mechanism and they are so -called pumps with a shredder.
What are pumps with a shredder used for?
The basic function of shredding pumps, as the name suggests, is to crush sewage and deposits to increase the efficiency of their transport and pumping. Pumps with a shredder They are widely used in the water and sewage sector for pumping sewage with fibrous impurities. It is worth using them in the case of backgrounds with small diameters and in a situation where sewage is transported over considerable distances. A condition for installing a pump with a shredder is a large distance from the main sewage department. The pumps with a shredder work if the transport distance is greater than 300 meters, the height to emboss it exceeds 12 meters vertically, and the discharge pipeline is less than 40 millimeters. Pumps with a shredder are also used when large levels of terrain levels exclude the use of other solutions.
Pumps with a shredder are very often used for places that must be adapted to sanitary rooms, but are located outside the sewage department. Similarly, it is progressed in the case of kitchen islands, equipped with a sink. Pompornoes are also widely used in gastronomic establishments, and their basic function is in such cases to protect the sewage network against clogging with residues of food. They are also successfully used in beauty and hairdressing salons and in public toilets. They are used in the food, paper and agricultural industry as well as in hospitals, hotels and campsites.
What is worth knowing about pumps with a shredder?
The basic structural element of the pump with a crusher is the crushing mechanism, consisting of a knife and a cutting disc. Both parts should be made of tool steel with increased abrasion resistance. The shredding mechanism is installed in front of the rotor. The dirt is shredded in a hermetic pump tank. The knives cut solid pollution from sewage, and then the pump pump them into the sewage network, septic tank or home sewage treatment plant. Pumps with a shredder allow you to effectively adapt to field capabilities, which is particularly important in locations with complex terrain. The type of inlet to the pump adapts to the type of supported sanitary device - it will be different in the case of a sink, and another to a bidet or washing machine.
The pump housing must be resistant to mechanical damage and corrosion. Pumps with a shredder can be used to pump not only sewage, but also sludge and slurry. When choosing the right pump with a shredder, pay attention to the additional equipment with the thermal fuse. Pomporno -designers are also equipped with convenient switching on and off buttons as well as an electronic control system. They are installed on a flat ground, about 5 centimeters from the wall or integrates with a toilet bowl. Cripper is an increasingly common solution in channel pumps.
